Technoline WQ 323 Manual descargar pdf (Pagina 2)

4. In count up mode, press TALK/LIGHT key to speak out the current count up time. If

LIGHT switch is at ON position then backlight will also light up for 5 seconds.

Talking count up time intervals:

First 10 seconds: The clock will speak out the current count up time.

10 second to 1 minute: The clock will speak out the current count up time every 10

seconds.

1 minute to 10 minutes: The clock will speak out the current count up time every 1

minute.

After 10 minutes: The clock will speak out the current count up time every

10 minutes.

5. Press MODE key to return to normal time mode and speak out the current time. If under

normal time mode or alarm mode, the clock will NOT speak out the current count up time

as mentioned above. If count up time is not reset or paused, the clock will keep counting

up.

Alarm time setting

1. In normal time mode press MODE key to enter into the following alarm time:

Count up Æ Alarm 1 Æ Alarm 2 Æ Alarm 3 Æ Alarm 4 Æ Return

2. In any alarm mode, press UP key to turn on or off the current alarm function.

3. In Alarm 1 mode, press SET key for a while to enter into Alarm 1 time setting. The

following setting digits will flash in sequence: Alarm 1 hour Æ Alarm 1 minute

4. Use UP key to select the digit. Press UP key for a while to speed up the digit

up-adjustment.

5. The same setting is applied to Alarm 2, Alarm 3 and Alarm 4.

If there’s no any key pressed in 30 seconds, the clock will exit the alarm mode and return to

normal time mode and the clock will make two BEEP sounds.

Consideration of duty according to the battery law

Old batteries do not belong to domestic waste because they could cause damages of health

and environment. End-users are committed by law to bring back needed batteries to

distributors and other collecting points!

1 2

Sin comentarios

Technoline WQ 323 Manual Pagina 2